Notifier AFC-600 - How the Control Panel Works in Normal Operation

)LJXUH  .HOWURQ 3ULQWHU &RQQHFWLRQV
6HWWLQJ XS WKH .HOWURQ 3ULQWHU
Set up a Keltron printer as follows:
1. The printer communicates using the following protocol:
• Baud Rate: 9600 • Parity: Even • Data bits: 7
2. Set the printer DIP switches SP1 and SP2 according to settings in table below:
7DEOH  .HOWURQ ',3 6ZLWFK 6HWWLQJV
,QVWDOOLQJD&57
1RWH
)RU GHWDLOHG LQIRUPDWLRQ RQ VHWWLQJ XS WKH &57 UHIHU WR $SSHQGL[ ( 7HUPLQDO ,QWHUIDFH 3URWRFRO
Connect a CRT-2 to the CPU as follows:
Step Action
1 Connect the three (3) open leads of the custom cable to the TB2 terminal
block on the CPU-600 as shown in the figure below.
2 Plug the DB-25 connector end of the custom cable into the EIA-232 port of
the CRT-2. Tighten securely.
35,17(5
7; 5; 5()
3&7(50,1$/
7; 5; 5()
7%
7%

7%
±±±
±
.HOWFRQQFGU
'% FRQQHFWRU
.HOWURQ SULQWHU  9'&
FRQQHFWLRQV WR 036
 $:*
036
&38
SP1 On Off
1X
2X
3X
4X
5X
6X
7X
8X
SP2 On Off
1X
2X
3X
4X
5X
6X
7X
8X
 ,QVWDOODWLRQ Installing Remote Printers and a CRT
74 AFC-600 Installation PN 51031:B 03/28/2001
Technical Manuals Online! - http://www.tech-man.com