14 NFS2-640/E Operations Manual — P/N 52743:F1 06/16/2011
Use of the Controls Programming Keypad
• Turns off the SIGNALS SILENCED LED
• Sends a Manual Evacuate message to the History buffer and installed printers, CRT-2
terminals, and FDU-80 annunciators
2.3.5 Lamp Test
Use the LAMP TEST key to test the control panel LEDs and the panel sounder. When pressed and
held, the control panel does the following:
• Lights all control panel LEDs
• Turns on the panel sounder
• Lights all segments of the LCD display. When the LAMP TEST key is held for longer than five
seconds, the LCD will display the Software Revisions.
2.4 Programming Keypad
The programming keypad includes:
• Function keys: DETECTOR, MODULE, OUTPUT, BATTERY LEVELS, NEXT SELECTION, PREVIOUS
SELECTION, RECALL LAST ENTRY, and INCREMENT NUMBER
• ENTER key
• Cursor movement keys: ESC/LEFT ARROW key, UP key, RIGHT key, DOWN key
• Alphabetic and numeric keys, with LOWER CASE selection key
NOTE: If Local Control is set to “0” (No Control) or “2” (Partial Control), the FACP will not
respond to DRILL.
To Next Page
Loading...
