QR-9
10. Place a drop of control solution from
the bottle to the end of the test strip
until the solution is drawn into the
well of the test strip. When enough
sample has been drawn into the strip,
an audible beep is sounded by the
meter.
11. Recap the control solution. The
Testing Sample screen displays.
The screen shows a clock with seconds remaining below
the clock.
12. When the meter completes the test, the QC Result screen
displays with the results in mg/dL or mmol/L.
Touch test strip to Level 1 QC drop
Remove test strip to cancel test
Op: 8636
Apply Sample
13:42
Name: ED
To Next Page
Loading...
