Nova SM908

2
Safety Instructions
z Always read the safety instructions carefully.
z Keep this User's Manual for future reference.
z Keep this equipment away from humidity.
z Place this equipment on a reliable flat surface before setting it up.
z Do not stand it on soft furnishings.
z If any of the following situation arises, get the equipment checked by a service technician:
- The equipment has been exposed to moisture.
- The equipment has been dropped and damaged.
- The equipment has obvious sign of breakage.
- The equipment has not been working well or you cannot get it work according to User's Manual.
Warning
z To prevent the risk of electric shock, do not open the cover or the back of the receiver.
z Do not block the ventilation holes of the device. Leave appropriate gap above and around it to allow for
adequate ventilation.
z Do not place the device in an unventilated cabinet or on top of a unit which emits heat.
z Danger of explosion if battery is incorrectly replaced. Replaced only with the same or equivalent type.
z The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
z The mains plug is used as the disconnect device, the mains plug shall remain readily operable.
z To reduce the risk of fire or electric shock, do not expose this apparatus to rain or colds.
Copyright Statement
No part of this publication may be reproduced in any form by any means without the prior written permission.
Other trademarks or brand names mentioned herein are trademarks or registered trademarks belong to
EIGHT Limited.
Disclaimer
Information in this document is subject to change without notice. The manufacturer does not make any
representations or warranties (implied or otherwise) regarding the accuracy and completeness of this
document and shall in no event be liable for any loss of profit or any commercial damage, including but not
limited to special, incidental, consequential, or other damage.
This symbol indicates that this product incorporates double insulation between hazardous mains
voltage and user accessible parts. When servicing use only identical replacement parts.