8
Installing the Batteries
To install AAA size batteries for remote control:
Remove the battery cover from the remote control and put two AAA size batteries inside the compartment.
The diagram shows the correct way to install the batteries.
Caution:
1. Keep batteries out of children’s reach.
2. Don’t attempt to recharge, short-circuit, disassemble heat or throw the batteries into the fire. Always
replace both batteries at the same time. Never mix new and old batteries or batteries of a different type.
3. If you don’t intend to use the remote controller for an extended period, remove the batteries to prevent
possible leakage and corrosion.
4. Do not drop, apply shock or step on the remote control.
5. Do not spill water on the remote control.
Notes: If the receiver does not operate from a close range, please replace with a fresh new set of batteries.
Using the Remote Control
1. To use the remote control, point it towards the front of the digital set top box.
2. The remote control has a range of up to 8 meters from the set top box at an angle of up to 60 degrees.
3. The remote control will not operate if its path is blocked.
Note: Sunlight or very bright light will affect the sensitivity of the remote control.
To Next Page
Loading...