ML0021 August 15, 2018
151 Copyright 2018 Bitronics, LLC
directly by an M871 is configured to initiate an oscillography recording and make an
SOE Log entry. (Only Phase-A Amps is shown, but the Trigger window scrolls
vertically and can hold up to 120 separate independent events.)
Figure A 13
2. The condition “Waveform Recorder 1 Active” is used to drive a Virtual Output that is
linked to a GSSE message as illustrated in Figure A14. A Virtual Output can be driven
by individual conditions (like RMS Amps A1 > 2000, in this example) or it could be the
result of a combination of several conditions defined through rudimentary triggering
logic.
Figure A 14
Note: “Waveform Recorder 1 Active” can be considered to be a self-initializing
To Next Page
Loading...
