ML0021 August 15, 2018
155 Copyright 2018 Bitronics, LLC
APPENDIX B
Firmware Version History
v2.05 New features
- Support for new Mx72 hardware (dual bus signal inputs).
- Support for new P40 module (transducer inputs).
- Added the following new measurements: bus 2 currents, bus 2 power,
bus 2 energy, bus 2 demands, unbalanced, transducer inputs.
- Added voltage fluctuation table
- Improved SOE log including adding user’s message
- Support CT wiring of CBA.
- All Digital Inputs are now recorded in Waveform Recorders.
- Digital inputs can support resetting the demands
- Created counters for digital and virtual inputs
- Added Zmodem command “attrib” .
- Added Recorder Active Bits for DR1,DR2,WR1,WR2.
Maintenance upgrades
v2.06 Maintenance upgrade
v2.12 New Features
- AND/OR logic and timers for triggers for virtual outputs
- Added the derivative of any measurement that has a rate of change
trigger to the measurement database
- Auto Event Notification
Maintenance upgrade
v2.15 Maintenance upgrade
v2.17 New Features
- Fault location (distance-to-fault)
- Adjustable sampling rate on waveform capture
Maintenance upgrade
V2.18 New Product Release
Added per phase Watts ,VAr, & VA.
Configurator & Biview improvements w/ modems.
Change to Digital I/O default watchdog contact (Configurator (setup not
firmware dependent).
Support new version of hardware on P3x, P4x modules.
V3.01 New Product Release
Implementation of IEC 61850 protocol
Added Support of SNTP for time synchronization
Added average 3-phase Amps & average 3-phase Volts
V3.02 New Product Release
To Next Page
Loading...
