Novitool Aero - Personal Safety and Proper Use

www.flexco.com
—8—
General Safety Rules – Save These Instructions
Do not wear loose clothing or jewelry. Keep your
hair, clothing, and gloves away from moving
parts. Loose clothes, jewelry, or long hair can be
caught in moving parts.
When moving in transport case, ensure casters are
unlocked and case is latched securely.
Abide by all instructions and warning labels.
is equipment is not to be used by children or
persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge
of the equipment.
4. USE AND CARE
!
WARNING
Read and understand Aero® operations manual
before using machine.
Do not store solvents in Aero® transport case.
!
CAUTION
Only operate Aero® with machine positioned on a
level, rm surface.
NEVER use a machine which is defective or
operating abnormally. If machine appears to
be operating unusually, making strange noises,
or otherwise appears defective, stop using it
immediately and arrange for repairs.
Do not use machine if switch does not turn it on
or o. Any machine that cannot be controlled
with a switch is dangerous and must be repaired.
Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that may aect machine operation. If damaged,
have machine serviced before using.
In order to maintain air ow, do not cover the air
inlets on top, at ends and on sides where air ows
through.
Maintain machine in clean condition. Remove
any oils, greases, or food product from outside
and inside machine.
Never alter or remove safety devices.
Never operate press with an extension cord.
!
WARNING
Operating press on incorrect voltage can cause
serious damage and potential hazards. Available
Aero® power cords:
• 110 volt; single phase
• 230 volt; single phase
• 230 volt; three phase
• 400 volt; three phase + neutral
• 400 volt; three phase
• 460 volt; three phase
Do not use outdoors. is machine is designed
for indoor use only. e press must be
transported in transport case when outdoors.
Inspect machine before each use. Ensure
machine and power cable are not damaged.
Machine shall not be operated with damaged
controllers, power cords, or other mechanical
components.
Avoid dropping or severe handling of machine
at all times, including during movement in
transport case.
If the electrical supply cord is damaged, it must
be replaced by a special cord available from the
manufacturer or it’s service agent.
3. PERSONAL SAFETY
!
WARNING
Use safety equipment. Always wear eye
protection, gloves, non-skid safety shoes, and
adhere to other safety standards of the facility
where operating the press.
Stay alert, watch what you are doing, and use
common sense when operating a machine. Do
not use machine while tired or under inuence
of drugs, alcohol, or medication. A moment of
inattention while operating machines may result
in serious personal injury.