www.nvcnc.com
Chapter4 Setting of software
Manual of NVUM_SP
- 28 -
Click “Spindle Setup” switch to the spindle settings page. See as Figure4-12.
Figure4-12. Spindle Settings dialog
Here we can configure the spindle rotates
、
CW Reverse
、、
CCW Mist Flood pin, See as
Figure4-
，
13 They have been configured
、、、
as 1 2 3 4. Corresponding to output#1~output#4 in
Figure4-14.output#1~output#6 in Output Signal Setup dialog can be Configured into these 4
signals. Here we only configure CW \MIST\FLOOD. They are M3\M7 and M8 in G-code file.
CW is controlled by OUT1 and MIST is controlled by OUT2 and Flood is controlled by OUT3.
Here we note correspondence between 2 page. Please select “use spindle motor output” if required
PWM speed spindle. And select “ PWM Control”. Our PWM pin fixedly arranged on a special pin,
it’s no need to be set.
Figure4-13. Spindle setting corresponds to the output configuration
To Next Page
Loading...
