Novy 1801 - Pan Detection System Operation; Residual Heat Indicator and Warnings; Power and Super Power Functions

– 60 –
Switching a cooking zone on and off
Set up
Display
Press the cooking zone selection button.
00
Switch off
0
H
Press the cooking zone selection buttons
and
simultaneously until the display shows
0
or
H
= “hot”.
If there is no control input within 20 seconds, the electronics will
return to the wait position.
4.1.3 Pan detection
The cooking zone that has been switched on is only active
when a cooking pan is detected by the pan detection system.
The induction hob does not work:
– If there is no pan on the cooking zone or if the pan is
unsuitable for induction. In this case, it is impossible to put
the power on and the
symbol will ash on the display.
– The operation is suspended when the pan is removed from
the cooking zone during cooking. The
symbol will ash
on the display. The
symbol will disappear when the pan is
placed back onto the cooking surface. The cooking will then
continue at the same power level as selected previously.
Switch o the cooking zone after use.
4.1.4 Indication of residual heat
After the cooking zone or hob has been switched o completely,
the hob glass will still be warm, which can be seen by
H
. The
H
symbol disappears when the cooking zone glass can be
handled without danger.

WARNING: As long as the residual heat indication
remains active, the cooking zone(s) must not be
touched and no heat-sensitive items should be
placed on the cooking zone. Risk of fire and burns.
4.1.5 Power function
Power function
P
boosts the power to the selected cooking
zone. If this function is activated, these cooking zones will be
subjected to considerably higher power for 10 minutes.
The Power function is designed to quickly heat large quantities
of water, for pasta for example.
Switching Power on and off
Switch on power
Display
Press the cooking zone selection button.
Press the button and then the button
until P
P
Switch off Power
9‐0
Press on the button
Management of maximum power:
The hob is divided into 2 separate heating groups.
A2
A1
B2
B1
A1B1
B2
A2
88
8 8
If this power limit is exceeded when switching to a high
selected cooking heat or switching the power function on, the
power management module reduces the cooking position of
the relevant cooking zone. This cooking zone will rst ash,
and it is then automatically reduced to the maximum possible
cooking heat
Het maximale vermogen van de zones A1 en B2 is afzonderlijk
3000W en 1850W van de zones A2 en B1.
If simultaneous cooking is taking place on zones A1 and A2 or
B1 and B2, the power of 3700 W is divided between these 2
zones A1 and A2 or B1 and B2.
Cooking zone in cm
Power (W)
A1
B2
24 x 20
24 x 20
Normal: 2100
Power: 3000
B1
A2
24 x 20
24 x 20
Normal: 1600
Power: 1850
Power limit
Display
Selected cooking zone with Power function
P
Power limit activated
8
[9] reduced to [8] and ashes
In order to be able to make use of the maximum possible power
for 2 zones at the same time, use a combination of zone A1 or
A2 and B1 or B2.