– 48 –
4.3 Controlling the hob
4.3.1 Switch on and off
Switching the hob on and off:
Switch on
Press and continue to hold for 2 sec
The display will light up
Switch off
Press
Display goes out
Switching a cooking zone on and off:
Set up
Display
Slide from left to right on the slider
(slider operation for power)
0‐9
Switch off
0
H
Slide from right to left on the SLIDER until the
display shows
0
or
H
= "Hot".
If there is no control input within 20 seconds, the electronics will
return to the wait position.
4.3.2 Pan detection
This hob is equipped with an interactive control system that
makes use of the hob even easier.
When you place a pan on the hob, it is automatically detected.
You will also see a
0
to show you which slider to use for the
zone in question. The pan detection ensures optimum safety.
The induction hob does not work:
– If there is no pan on the cooking zone or if the pan is
unsuitable for induction. In this case, it is impossible to put
the power on and the
symbol will flash on the display.
– The oper
ation is suspended when the pan is removed from
the cooking zone during cooking. The
symbol will flash
on the display. The
symbol will disappear when the pan is
placed back onto the cooking surface. The cooking will then
continue at the same power level as selected previously.
Switch off the cooking zone after use. The pan detection
will
no longer be active.
4.3.3 Indication of residual heat
After the cooking zone or hob has been switched off completely,
the hob glass will still be warm, which can be seen by
H
. The
H
symbol disappears when the cooking zone glass can be
handled without danger.
WARNING: As long as the residual heat
indication remains active, the cooking zone(s)
must not be touched and no heat-sensitive items
should be placed on the cooking zone. Risk of
fire and burns.
4.3.4 Power function
The Power function
P
increases the power rating of the selected
cooking zone. If this function is activated, these cooking zones
will be subjected to considerably higher power for 10 minutes.
The Power function is designed to quickly heat large quantities
of water, for pasta for example.
Switching Power on and off:
Switch on power
Display
Glide your nger over the slider to the end or
push the end of the slider
P
Switch off Power
9‐0
Glide your nger over the slider
Management of maximum power:
The hob is divided into 2 separate heating groups.
A2
A1
B2
B1
If this power limit is exceeded when switching to a high
selected cooking heat or switching the power function on, the
power management module reduces the cooking position of
the relevant cooking zone. This cooking zone will rst ash,
and it is then automatically reduced to the maximum possible
cooking heat
The maximum individual power for each zone is 3700 W.
If simultaneous cooking is taking place on zones A1 and A2 or B1
and B2, the power of 3700 W is divided between these 2 zones
A1 and A2 or B1 and B2.
Cooking zone in cm
Power (W)
A1
A2
B1
B2
24 x 21
24 x 21
24 x 21
24 x 21
Normal: 2100
Power: 3700
Power limit
Display
Selected cooking zone with Power function
P
Power limit activated
8
[9] reduced to [8] and ashes
In order to be able to make use of the maximum possible power
for 2 zones at the same time, use a combination of zone A1 or
A2 and B1 or B2.
To Next Page
Loading...
