Novy Easy - 4.3.4 Power function; 4.3.5 Timer function; 4.3.6 Programming auto heat up

– 49 –
4.3.5 Timer function
The timer function allows all cooking zones to be used
simultaneously for different periods of time (0 to 1H59 minutes)
for each zone.
Timer function
Setting or changing the cooking time
Display
Select the power by gliding your nger over the
slider
1‐P
Select the timer
Press the timer icon above the zone selection
key for the required cooking zone
Reduce the time
0 0 1‐
1 5 9...
Press [–] on the timer
Increase the time
0 6 0‐
0 5 9...
Press [+] on the timer
After a few seconds the LED
no longer ashes. The time
has been selected and the countdown has begun.
Switch off the timer function
Select the timer
Display
Press the timer icon above the zone selection
key for the required cooking zone
Stop the timer
0 0 0
Keep pressing [–] on the timer until the timer
displays
000.
If different timers are to be activated on multiple zones, this
operation must be repeated several times. The activated timer
indication no longer lights up above the relative cooking zone.
The timer can also be used as an independent cooking alarm
without selecting a cooking zone. If the hob is to be switched
off, the independent cooking timer will continue until the end of
the set time.
Using the timer without cooking:
Timer without cooking
Display
Switch on the hob.
Press
for 2 seconds.
Wait 10 seconds
Select the timer
0 0 0
Press the timer indicator [000]
Reduce the time
0 6 0‐
0 5 9...
Press [–] on the timer
Increase the time
0 0 1‐
0 0 2...
Press [+] on the timer
After a few seconds the timer display stops ashing. The time is
selected and counting down starts.
Turn off automatically at the end of the cooking time:
As soon as the selected cooking time is up, the display will ash
‐‐‐
, a beep will be heard. To stop the audible signal and the
ashing, press [
000
] on the timer.
4.3.6 Programming auto heat up
All cooking zones are equipped with an auto heat up function.
The cooking zone will initially operate at full power for a certain
amount of time before automatically reducing to the selected
power level.
Programming auto heat up:
Activating auto heat up
Display
Glide your nger over the slider to (for example)
7
and hold for 3 seconds
7 A
Switching auto heat up off
Display
Glide your nger over the slider
0
to
9
0‐9
Auto heat up table
Set value for cooking time Auto heat up function
Time (min:sec)
1
0:40
2
01:12
3
02:00
4
02:56
5
04:16
6
07:12
7
02:00
8
03:12
9
--:--