Machine operation instructions
Machine Activation:
Plug in the mains cable and switch on the illuminated MAINS POWER SWITCH
located at the left side of the machine.
See: Pelletizer main layout overview (1).
Activating the machine will illuminate the touchscreen, readying it for operation.
In the next section, the touch screen operation modes are explained.
Interface
Interface modes
There are two main operation modes, auto mode and manual mode.
Manual mode provides greater flexibility over the desired result. This mode
works with both pre-extruded filament and directly from a live extruder.
It’s important to keep in mind that when using direct extrusion, the roller speed
must match the extrusion speed of the extruder.
Auto mode is designed for use with pre-extruded filament, for example, directly
from a spool. It features pre-set values for ease of use. It is not recommended to
use this mode when feeding filament directly from a live extruder because the
speeds are set and may not match your extrusion speed.
In the following section, both modes are elaborated upon in greater detail.
10
To Next Page
Loading...