10
Program selection
1) Press SELECT key until program number displayed blinks at the normal display.
2) Press
/ key to select the program number that you want to use.
3) Press ENTER/SAVE key for 3 seconds or longer. The selection is completed.
NOTICE Ř When the program you selected is modified, the color of “PRG” will inverse.
8
ERROR CODES
8–1 NLX nano MOTOR
The system incorporates an automatic diagnosis feature that can help to diagnose the cause of the problem
LQWKHHYHQWRIIDLOXUHPRGH:KHQWKHV\VWHPKDVIDLOHGWKHGLVSOD\ZLOOVKRZDQœ(ŎŔFRGHDQGPHVVDJH
Details of each error code are listed below.
Error
code
Error Message Cause Solution
E–00
Over current (Hard) Excessive torque is loaded. Remove the load from motor.
E–01
Over current (Soft1)
Abnormal electric current applied to
motor and circuit.
Release the foot control.
E–02
Over current (Soft2)
Excessive current is applied for a given
time.
Release the foot control.
E–03
Fault error Overcurrent in the motor driver. Contact your Authorized NSK Dealer.
E–04
Over heat Motor is overused. Leave the motor is until it cools down.
E–05
Input over voltage Over voltage. Contact your Authorized NSK Dealer.
E–06
Lamp over voltage Lamp circuit over voltage. Contact your Authorized NSK Dealer.
E–07
Residual voltage Output circuit error. Contact your Authorized NSK Dealer.
E–08
Over load
The load continued to exceed the
limiter during the fixed time.
Remove the load from motor/
handpiece, and release foot control.
E–09
Motor start failure
Handpiece/motor cord disconnection.
Check the handpiece cord is connected
with the handpiece properly.
Electric circuit may fail. Contact your Authorized NSK Dealer.
E–10
Lamp under voltage Lamp circuit under voltage. Contact your Authorized NSK Dealer.
E–13
Esc error Over motor control range.
Remove the load from motor/
handpiece, and release the foot control.
E–14
EEPROM error Memory read/write data error. Contact your Authorized NSK Dealer.
To Next Page
Loading...
Need help?
General