12
9
OTHER SETTINGS
For each setting, follow the process below.
1) Ensure the Motor and the Scaler have completely stopped.
2) For normal display, press and hold SET UP key for 3 seconds or longer, then “User setting menu” will be
displayed.
3) Use
/ key to select the item you wish to change.
4) Press ENTER/SAVE key, then select the item (Perform this process to change the settings after a setup
indicated in 9–1 and 9–2”).
5) Press and hold ENTER/SAVE key for 3 seconds or longer to save the program.
NOTICE Ř At the setting mode, when you move back to the previous screen, use the ESC key. If you
press ESC key without setting, the menu below will appear. Follow the instruction on the
display.
9–1 MOTOR SETTINGS
9–1–1 [1. Language] : Setting the display language.
9–1–2 [2. Gear ratio] : 2 of 10 Gear ratio settings can be set for customized settings.
To move the cursor, press the SELECT key.
7KH*HDUUDWLRFDQEHVHW>WR@RU>WR@
The right side or the left side should be 1.
1.Language English
2.Gear ratio Español
3.Lamp Italiano
4.Endo mode Français
5.Air Deutsch
6.Endo alert
7.Others
8.Version
1.Language
2.Gear ratio
Gear ratio 1 >Ŏ@RU>Ŏ@
3.Lamp Gear ratio 2
>Ŏ@RU>Ŏ@
4.Endo mode
$GMXVWDEOHUDQJH
5.Air
6.Endo alert
7.Others
8.Version
To Next Page
Loading...
Need help?
General