13
English
9–1–3 [3. Lamp] : For setting the function of the LED.
At setup mode, select “Lamp” on the screen. Then you will see the next selection shown below diagram.
Ř2Q2II 6HWWLQJWKH0RWRU/DPSRQRII
Ř,QWHQVLW\ 6HWWLQJWKHLQWHQVLW\RIWKH0RWRU/DPS91/;9L0''HIDXOWVDUH
3.5V(NLX) / 3.3V(iMD).
Ř'HOD\WLPHU6HWWLQJWKHGXUDWLRQRIOLJKWLQJDIWHUWKH0RWRULVXVHGŎVHFRQGV'HIDXOWLV
sec.
9–1–5 [5. Air] : Calibration for air driven foot control.
Air pressure may vary on the dental chair unit. The foot control of the Multi Pad system has a feature for
synchronizing the motor speed with the air pressure.
Adjust the air pressure within a range shown below by adjusting foot control. When a message of “under” is
displayed, air pressure is too low. When a message of “over” is displayed, air pressure is too high.
Ř'LVSOD\VHWWLQJ&KDQJLQJDLUSUHVVXUHXQLWGLVSOD\SVLEDU03D6HOHFWWKHXQLWWKDW\RXZDQWWRXVH
Ř0RWRU0,1SUHVVXUH6HWWLQJWKHDLUSUHVVXUHIRUWKHPRWRUVWDUWŎXS
(4.3 – 14.5 psi or 0.30 – 1.00 bar, 0.030 – 0.100MPa).
Ř0RWRU0$;SUHVVXUH6HWWLQJWKHDLUSUHVVXUHIRUUHDFKLQJWKHPD[0RWRU5RWDWLRQ
(29.0 – 58.0 psi or 2.00 – 4.00 bar, 0.200 – 0.400MPa).
9–1–4 [4. Endo mode] : Endo (endodontics) mode setting.
This setting is not applicable to the NLX nano motor.
1.Language
2.Gear ratio
3.Lamp On / Off On / Off
Case of iMD
4.Endo mode Intensity Ŏ91/; 9L0'
5.Air Delay timer ŎVHF
6.Endo alert
$GMXVWDEOHUDQJH
7.Others
8.Version
NOTICE Ř The setting items of “Intensity” and “Delay timer” will be displayed only when lamp setting is
“On”.
1.Language
2.Gear ratio
3.Lamp
4.Endo mode
Display setting
Ncm
5.Air Nmm
6.Endo alert %
7.Others Auto REV time ŎVHF
8.Version Auto FWD time 1.0 – 3.0 sec
$GMXVWDEOHUDQJH
1.Language
2.Gear ratio
3.Lamp
4.Endo mode
Display setting
psi
5.Air bar
6.Endo alert MPa
7.Others Motor MIN pressure ŎSVLŎEDUŎ03D
8.Version Motor MAX pressure ŎSVLŎEDUŎ03D
$GMXVWDEOHUDQJH