Read me First!
Observe safety measures for operation with devices containing sources of laser radiation.
Do not stare into the beam. A label warning about the presence of laser radiation is
attached to the laser sources (Fig. 1).
Fig. 1
Before you start working with the instrument, get acquainted with the basic safety
measures and the operation conditions for the instrument!
If you are a beginner in scanning probe microscopy, we recommend you to familiarize with
basic SPM techniques. “Fundamentals of Scanning Probe Microscopy” by V.L. Mironov
gives a good introduction to the subject. This book is available free of charge at
https://www.ntmdt-si.com/customer-support/manuals/textbook.
Feedback
Should you have any questions, which are not explained in the manuals, please contact the
Service Department of the company (support@ntmdt-si.com) and our engineers will
give you comprehensive answers. Alternatively, you can contact our staff on-line using
the ask-on-line service (http://online.ntmdt-si.com/online).
To Next Page
Loading...