NT-MDT NTEGRA Spectra - 2.2. Mounting the Optical Tube

To Next Page

To Previous Page

NTEGRA Spectra Probe NanoLaboratory. SNOM Measuring Head. Instruction Manual

M4×16 screws (pos. 2 in Fig. 2-2) with Allen key wo fix the panel on the

exchangeable mount.

Fig. 2-2. Replaceable panel mounted on the base unit

1 – screws for fastening to the base unit; 2 – screws for fastening to the exchangeable mount

This completes mounting the replaceable panel on the base unit.

2.2. Mounting the Optical Tube

To mount the optical tube on the base unit, perform the following steps:

1. If necessary, mount the scanner in the positioning device as follows:

a. Release the spring stops of the exchangeable mount (Fig. 2-3) and place the

scanner in the positioning device as shown in Fig. 2-4.

Fig. 2-3. Spring stops

Fig. 2-4. Scanner mounted in the positioning

device

b. Lower the scanner to its extreme by rotating the approach knob clockwise

(Fig. 2-5). This is necessary for mounting the optical tube.