Chapter 2. Assembling of the SNOM Module
Fig. 2-5. Approach knob of the base unit
c. Connect the scanner to the base unit:
- When using a scanner with sensors, connect the scanner slot to the
SCAN+SENSOR located on the base unit.
- When using a scanner without sensors you may connect the scanner
connectors to the
SCANNER slot or to the SCAN+SENSOR slot.
ATTENTION! Switch the instrument off before any operation on
connecting/disconnecting its cable connectors. Disconnecting or
connecting the cable connectors during operations may cause damage
to the electronic circuit and disable the instrument.
2. Secure the optical tube on the positioning device with four M2×6 screws as shown in
Fig. 2-6.
Fig. 2-6. Optical tube mounted on the positioning device
knob
19
To Next Page
Loading...