EasyManua.ls Logo

NTI TRX120 User Manual

Default Icon
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Heat Exchanger Bears the ASME “H” Stamp
THIS MANUAL MUST ONLY BE USED BY A QUALIFIED INSTALLER /
SERVICE TECHNICIAN. READ ALL INSTRUCTIONS IN THIS MANUAL BEFORE
INSTALLING. PERFORM STEPS IN THE GIVEN ORDER. FAILURE TO DO SO
COULD RESULT IN SUBSTANTIAL PROPERTY DAMAGE, SEVERE PERSONAL
INJURY, OR DEATH.
DANGER
Improper installation, adjustment, alteration, service, or maintenance
could void product warranty and cause property damage, severe personal
injury, or death.
California Proposition 65 Warning: This product contains chemicals known
to the State of California to cause cancer, birth defects, or other reproductive
harm.
WARNING
The manufacturer reserves the right to make
product changes or updates without notice
and will not be held liable for typographical
errors in literature.
The surfaces of these products contacted by
potable (consumable) water contain less
than 0.25% lead by weight as required by
the Safe Drinking Water Act, Section 1417.
NOTICE
TRXTRX
Residential Condensing Gas Boiler
INSTALLATION
START-UP
MAINTENANCE
TRX085
TRX120
TRX110C
TRX150C models
Series ii
Series ii

Other manuals for NTI TRX120

Questions and Answers:

NTI TRX120 Specifications

General IconGeneral
BrandNTI
ModelTRX120
CategoryBoiler
LanguageEnglish

Summary

Part 1 - General Safety Information

A. Operation and Installation Warnings

General warnings for safe operation and installation practices.

B. Improper Combustion

Hazards and precautions related to improper combustion.

Part 3 - Prepare the Boiler for Installation

E. Wall Mounting Instructions

Detailed steps for physically mounting the boiler on various wall types.

G. Exhaust Vent and Intake Pipe

Requirements and methods for installing the venting system.

H. Carbon Monoxide Detectors

Mandates and placement guidelines for CO detectors.

Part 4 - Water Piping

G. CH and DHW Pressure Relief Valves

Installation and operation of pressure relief valves for safety.

Part 5 - Venting

B. Approved Materials for Exhaust Vent and Intake Pipe

List of approved materials and standards for vent piping.

G. Exhaust Vent and Intake Pipe Installation

Detailed steps for installing the vent and intake piping system.

Part 6 - Installing the Condensate Drain

Part 7 - Connecting Electrical Service

A. Wiring

General wiring practices and grounding requirements.

Part 8 - Gas Connections

B. Gas Connection Requirements

Specific requirements for gas line installation and connections.

Part 9 - Controls

E. Setup wizard

Step-by-step guide for initial boiler setup and configuration.

H. Tech Menu

Accessing advanced technical settings and parameters.

I. TEST MODE

Procedures for testing boiler components and functions.

K. Diagnostic

Accessing diagnostic information, error history, and statistics.

Part 10 - Start-Up Preparation

A. Check / Control Water Chemistry

Verifying and adjusting water chemistry for optimal performance.

B. Check for Gas Leaks

Procedures for detecting and addressing gas leaks.

D. System Water Fill, Purge, and Test

Steps for filling, purging, and testing the heating system.

Part 11 - Start-Up

A. First Ignition

Steps for the initial ignition sequence and setup.

B. Combustion Checking Procedure

Steps for checking and adjusting combustion parameters for safety and efficiency.

C. Converting the Appliance from Natural Gas to Propane Operation

Instructions for converting the boiler from natural gas to propane.

Part 12 - Installation Checklist

Part 13 - Troubleshooting

A. Boiler Protection Devices

Understanding boiler protection mechanisms and error codes.

B. Boiler Error Codes

A detailed list and explanation of boiler error codes.

Part 14 - Maintenance

C. Maintenance Only to be Performed by a Qualified Service Technician

Maintenance tasks requiring professional expertise.

Related product manuals