Need help?Do you have a question about the Ntron OxyTX and is the answer not in the manual?
General| Protection Class | IP65 |
|---|---|
| Technology | Optical |
| Output | 4-20 mA, RS485 Modbus |
| Process Connection | 1/2" |
| Housing Material | Stainless steel |
Details the ATEX marking and intrinsic safety parameters for hazardous area operation.
Provides general wiring notes and detailed pin assignments for power, signal, and sensor connections.
Lists tools for calibration and explains the menu system access via buttons for configuration and calibration.
Explains how to perform zero calibration using zero gas and the procedure via menu mode C:1.
Details the process for sensor span calibration using a known gas concentration via menu mode C:2.
Explains how to set the 4mA output level by simulating zero gas conditions using a multimeter.
Details setting the 20mA output level by simulating full-scale gas conditions with a multimeter.
Explains the typical sensor life and when it should be replaced.
Provides a step-by-step guide for removing the old sensor and installing a new one.
Lists technical specs for the transmitter, including enclosure, power, output, range, and approvals.
Details specifications for the oxygen sensor, such as type, life, operating humidity, and certification.
To Next Page
