MEGAWATT CARBON BIKE MANUAL | 1 4
9. Push the valve through the valve hole. 10. Put the o-ring on the valve.
11. Fit the tubeless valve nut and tighten. 12. Start to refit the tyre, leave 1⁄4 open.
13. Add tubeless sealant as per sealant manufacturer
recommended amount.
14. Finish fitting tyre. Make sure the bead is pushed to the
centre of the rim as this will make it much easier.
15. Connect your tubeless pump to the valve. 16. Charge the tubeless pump cannister and then release
air blast.
To Next Page
Loading...
