NUM 1040 M - Page 128

5 - 6 en-938821/2
5.1.1.2 Selection of Manual Mode
Requirements
No mode being executed. If a mode is being executed, selection of manual mode is only taken into account after an
interruptible block.
Actions
Select the Mode softkeys. ☞
MODE
Display of the Mode softkeys at the bottom of the screen (See 3.1.4.3):
SINGLE MDI DRYRUN SEARCH EDIT TEST MANUAL HOMEAUTO
Select the manual mode. ☞
MANUAL
Display of the manual mode indicator in the status window (See 3.1.3).
Notes
In manual mode, the feed rate is controlled from the machine operator panel:
- by selecting fast jog speed,
- by turning the feed rate potentiometer.
5.1.1.3 Incremental Jog
Requirements
JOG softkeys selected (See 5.1.1.1).
Actions
Select an increment (0.001 to 10000 µm). ☞
.001
to
10000
Display of increment indicator in status window (See 3.1.3).
Select the manual mode (See 5.1.1.2).
Control the jog by momentarily pressing the axis controls of the machine panel.
Jog of one increment along the axis in the demanded direction (only one jog action can be performed at a time).
Notes
Pressing the "FEED STOP" button on the machine operator panel interrupts the jog being executed. Following this
interruption:
- pressing "CYCLE" restarts the jog,
- pressing cancels the remaining jog.