NUM 1040 M User Manual

en-938821/2 5 - 101
CNC Operation
5
Incidents
There is a syntax error in the filename.
Display in the dialogue window of one of the following messages:
Incorrect file name. Press any key...
Incorrect file extension. Press any key ...
Acknowledge the message. ☞
Key
No tool offset file is unloaded.
End of the Procedure
Exit from the page ☞
OUT
Exiting from the page does not interrupt loading in progress.

NUM 1040 M Specifications

General

Brand	NUM
Model	1040 M
Category	Controller
Language	English