Why does my Numark AXIS 8 CD Player have no sound?
If your Numark CD Player isn't producing any sound, there might be a couple of things to check: First, make sure the output cables are correctly connected. Second, verify that your amplifier is properly set up.
What to do if Numark AXIS 8 CD Player sound skips?
If the sound skips on your Numark CD Player, even with Anti-Shock™ enabled, it could be due to a couple of reasons. It might be that the CD player is experiencing vibrations or physical shock. Try changing the installation location. Also, the disc might be dirty, so try cleaning it.
How to fix Numark AXIS 8 disc play that does not start?
If your Numark CD Player isn't starting disc play, there are a couple of things you can check: First, make sure the disc is loaded with the label side up. If it is, the disc might be too dirty, so try cleaning it.
What to do if my Numark AXIS 8 CD Player has hum?
If you're experiencing a hum with your Numark CD Player, it's likely due to loose cable connections. Ensure that all audio plugs are firmly connected.
Why Numark CD Player power fails to switch on?
If your Numark CD Player isn't powering on, the issue might be a poor power plug connection at the AC outlet, or the IEC power cord might be loose from the rear of the unit. Ensure the power plug is firmly inserted into the AC outlet and that the connection is secure at the rear of the unit.
General| Type | CD Player |
|---|---|
| Playback Formats | CD, CD-R, CD-RW |
| Display | LCD |
| Channels | 2 |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | > 90 dB |
| Total Harmonic Distortion | < 0.01% |
| Pitch Control | ±8% |
| Outputs | RCA |
| Digital Output | S/PDIF |
| Power Supply | 110V - 240V, 50/60Hz |
To Next Page
