EasyManuals Logo

Numatic CRG 8055/100T User Manual

Numatic CRG 8055/100T
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
T 01460 68600
Machine Charging
The large capacity gel batteries are sealed for life and are totally maintenance free.
The on-board charger automatically monitors the charging process and will switch o󰀨 when the batteries are fully charged.
Note: The charging lead supplied with your machine may di󰀨er than the lead shown.
Once the charging lead has been connected the machine will be INHIBITED.
The battery charge indicator display lights will show the current charge state.
Always ensure that the machine is switched o󰀨 prior to charging.
!!
Machine charging point, above footplate. Insert country specic charging lead. Red charging indicator illuminates when
charging.
To ensure a full charge, the machine should be left until the charging indicator shows green.
Once fully charged, disconnect the charging lead from both the power supply and the machine.
Charging indicator (see page 16).
1. The battery meter displays the charge level of the batteries;
when fully charged, all meter lights are illuminated.
2. As the machine is used and the batteries are discharged,
the meter lights will go out from right to left.
3. When the battery meter turns RED the vacuum motor and the brush motor will stop. Once the motors have stopped, turn o󰀨 the
vacuum motor and lift the brush deck. Turn the key o󰀨 then back on. If required switch the vacuum motor on to pick up any remain-
ing liquid. Take machine to charging location and place on charge. Ensure the vacuum motor is switched o󰀨 and the machine is
turned o󰀨 by the key before charging.
Insert the charging lead required for your country into the charging point.
The machine charging point is located to the rear of the machine under the control panel.
Connect to a suitable power supply.
Once mains power is connected the red charging indicator will illuminate.
To ensure a full charge, the machine should be left for a period of 8 - 10 hrs.
Once fully charged, disconnect the charging lead from both the power supply and the machine.
2
3
1

Other manuals for Numatic CRG 8055/100T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Numatic CRG 8055/100T and is the answer not in the manual?

Numatic CRG 8055/100T Specifications

General IconGeneral
BrandNumatic
ModelCRG 8055/100T
CategoryDryer
LanguageEnglish

Related product manuals