9
T 01460 68600
Drive the machine to the cleaning site (read set-up guide again if necessary - page 5).
Before cleaning operation, place out appropriate warning signs and sweep or dust-mop the oor.
When ready for cleaning lower the oor tool (page 6) and the brush deck (page 7).
The vac shut o system stops the airow when the top waste water tank is full.
The vac motor will continue to run, there is an audible dierence in the sound when the shut o system operates.
For more details on checking and cleaning the shut o system see page 13.
Machine Operation
IMPORTANT
Do not operate machine unless the operator manual has been read and fully understood.
!!
Setting the Cleaning Controls
Waste Water Tank Full
Always ensure that the oor is pre-swept and relevant safety signs are displayed.
!!
Open Closed
Switch machine on. Battery charge-level
indicator illuminates.
Set the water ow rate as required. Switch the vacuum motor on.
Low High
H
E
A
V
Y
S
O
I
L
I
N
G
To Next Page
Loading...
Need help?
General
