8
www.numatic.co.uk
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean
water tank during the lling process. If using a bucket or similar, ensure it is always clean and free from debris.
When lling the clean water tank, do not
ll above the clean water tank emptying
hose retaining clip.
This can be found at the rear of
the machine.
Machine Set-up Guide
Always ensure that the machine is switched o before making any adjustments.
!!
The CRG 8055/8072 is equipped with a large capacity 80 litre clean water tank, allowing for large areas to be covered in a single
ll.
Filling the Clean Water Tank
Fill Level Indicator
If you need to access the batteries, make sure that the
waste water tank is empty before lifting.
!!
To ll clean water tank extend ll hose. Remove rubber seal and ll. Alternatively remove ller cap completely.
To Next Page
Loading...
Need help?
General
