Lower Anchor Use
The lower anchor belt can be used instead of a
vehicle belt to install this child restraint. The lower
anchor belt MUST NOT be used rear facing if your
child weighs more than 35 lb (15.8 kg), or forward
facing if your child weighs more than 40 lb (18.1 kg).
The lower anchor belt can and SHOULD be used
with the booster from 40–120 lb (18–54 kg).
The lower anchor belt and connectors are stored
under the rear facing True Tension
™
door.
Remove infant insert, loosen and unbuckle harness
(p.22), and unsnap seat cover.
1 - Lift rear facing True Tension
™
door release button.
2 - Take out the lower anchor belt and connectors.
3 - Lengthen lower anchor belt for use by pressing
adjuster button while pulling on belt.
4 - For belt routing, see p.46, p.54, or p.62. To
connect lower anchor belt to lower anchors
in vehicle, press connector firmly onto lower
anchor and pull to check. Lower anchor belt
MUST NOT interfere with the vehicle seat belt.
5 - Remove all slack from lower anchor belt by
pulling loop at end of belt.
6 - To release lower anchor belt, press red button
on end of connector while pulling on belt.
Store lower anchors when not in use. Place
one lower anchor connector in each half of
the storage compartment. Fold excess belt
webbing into compartment. Belt MUST NOT
interfere with latching of True Tension
™
door.
DO NOT cut the lower anchor attachment
strap. It permanently secures the lower anchors
to the child restraint.
36
EXEC
™
instructions
37
EXEC
™
instructions
2
4
3
5
6
1
To Next Page
Loading...
