Nuna mixx Series User Manual

Calf Support
The calf support has 3 use positions.
1 - To raise the calf support, lift up.
2 - To lower the calf support, press the adjustment buttons
on the sides (1), and push down (2).
Full Recline
Child may slip into leg openings and strangle.
NEVER use in reclined carriage position unless the calf
support is raised to cover the front opening and the
fabric flaps are snapped to the side of the stroller seat.
DO NOT use enclosure with an older child that can push
up on hands and knees or crawl out.
3 - Remove the arm bar before using the full recline.
Unfasten the front snaps from inside the seating area
on both sides of the seat.
4 - Fully recline the seat, rotate the footrest to the upright
position and unfasten the flaps underneath the calf
support.
5 - Fasten the flaps to the front snaps on the inside of the
seating area on both sides of the seat.
1
3
5
4
2
24 MIXX instructions 25MIXX instructions
1
1
2

Nuna mixx Series Specifications

General

Weight capacity	50 lbs
Suspension	All-wheel suspension
Maximum child weight	50 lbs
Frame material	Aluminum
Harness type	5-point
Car seat compatibility	Nuna PIPA series
Stroller width	23.6"
Folded width	23.6"
Seat facing directions	Parent-facing, World-facing
Compatibility	Nuna PIPA series