Nuna mixx Series - Product Set Up; Opening the Stroller Frame

Front Wheels
1 - Insert the front wheel into the front leg. A “click” sound
means the wheel is assembled completely.
Check the wheel is securely attached by pulling out.
Repeat on opposite side.
2 - To remove the front wheel, press the release button (1)
and detach the front wheel from the front leg (2).
Brake Assembly
Make sure the brake lever is facing up before attaching the
brake assembly to the frame.
3 - Push the brake assembly onto the rear leg tubes. A
“click” sound means the break assembly is attached.
Check that brake assembly is securely attached by
pulling out.
Rear Wheels
4 - Insert the rear wheel into the rear leg. A “click” sound
means the rear wheel is assembled completely. Repeat
on opposite side.
Check that the wheels are securely attached by pulling
them out.
5 - To remove the rear wheel, press the release button (1)
and detach the rear wheel from the rear leg (2).
click
click
1 4
52
3
14 MIXX instructions 15MIXX instructions
1
2
2
1
click