Nuna PIPA rx User Manual

Securing Child in Child
Restraint (continued)
1
- Listen for clicks. Pull on buckle
to verify it is latched.
2 - Snap the chest clip together
and temporarily slide towards
buckle for tightening of harness.
3 - Tighten harness by pulling
on the adjustment strap. Pull
any excess harness webbing
through the buckle towards the
child’s shoulders and pull on
the adjustment strap. This may
need to be repeated several
times for proper fit.
Verify that the harness is snug
around the child’s waist and
shoulders.
4 - Position the chest clip at child’s
armpit level.
Check that Child is Secure
Buckle is fastened.
Harness straps are not twisted.
Harness is snug – A snug
harness cannot be pinched
horizontally, and should not
allow any slack.
Chest clip is level with armpits.
(continued on the next page)
click
34 35PIPA rx instructions PIPA rx instructions
1
2
3
4
click

Nuna PIPA rx Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4 to 32 lbs
Height Capacity	Up to 32 inches
Canopy	UPF 50+ canopy with flip out eyeshade
Harness	5-point harness
Base Compatibility	PIPA series base
Safety Features	Side impact protection
Safety Standards	FMVSS 213
Compatibility	Nuna strollers with adapters
Installation	Belt path or with base using True lock™ base installation
Weight of Car Seat	7.6 lbs (without base)