EasyManuals Logo

Nuna PIPA rx User Manual

Nuna PIPA rx
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Child Restraint Only Install
This child restraint can be installed
without a base in 3 different ways.
1 - Place vehicle in park and on
level ground. Position child
restraint so that child is facing
the rear of the vehicle.
Only install in a forward facing
vehicle seat.
2 - Option 1: Route the vehicle lap
belt under both lap belt guides.
Buckle the vehicle belt. Allow
shoulder belt to lay against
vehicle seat back as shown.
3 - Option 2: Route the vehicle
lap belt under both lap belt
guides. Buckle the vehicle belt.
Route the shoulder belt around
the back of the child restraint
passing through the blue
shoulder belt guide.
4 - Option 3: If your vehicle does
not have a shoulder belt, the lap
belt only can be used.
5 - Adjust the angle of the child
restraint. A rolled up towel or
foam pool noodle may be used
to adjust the amount of recline.
6 - Angle is correct when blue line
on child restraint (located on
the label on the side of the child
restraint) is level with ground.
(continued on the next page)
1
2
3
4
5
6
56 57PIPA rx instructions PIPA rx instructions

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nuna PIPA rx and is the answer not in the manual?

Nuna PIPA rx Specifications

General IconGeneral
Product TypeInfant Car Seat
Weight Capacity4 to 32 lbs
Height CapacityUp to 32 inches
CanopyUPF 50+ canopy with flip out eyeshade
Harness5-point harness
Base CompatibilityPIPA series base
Safety FeaturesSide impact protection
Safety StandardsFMVSS 213
CompatibilityNuna strollers with adapters
InstallationBelt path or with base using True lock™ base installation
Weight of Car Seat7.6 lbs (without base)

Related product manuals