Nuna PIPA rx User Manual

1
2
3
4
5
6
14 15PIPA rx instructions PIPA rx instructions
These vehicle belts CANNOT BE
USED with your child restraint.
Install with lower anchors instead.
1 - Motorized Belts (Automatic)
These should not be used
unless the shoulder belt can be
removed, the lap belt is locked
and use is allowed by the
vehicle manufacturer.
2 - Dual Retractor Belts
If allowed by the manufacturer,
the lap belt only may be used
to secure the child restraint in
accordance with this manual
and the vehicle owner’s manual.
3 - Non-Locking (ELR) Lap Belts
This belt locks in a crash or
sudden stop and should only be
used with a belt shortening clip.
Contact your vehicle
manufacturer if needed.
4 - Airbag/Inflatable Belts
This belt cannot be used to
install this child restraint.
5 - Door Mounted Belts
This belt cannot be used to
install this child restraint.
6 - Lap Belts forward of Seat Bight
This belt (Where the seat
bottom and seat back meet)
should not be used to install
this child restraint.

Nuna PIPA rx Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4 to 32 lbs
Height Capacity	Up to 32 inches
Canopy	UPF 50+ canopy with flip out eyeshade
Harness	5-point harness
Base Compatibility	PIPA series base
Safety Features	Side impact protection
Safety Standards	FMVSS 213
Compatibility	Nuna strollers with adapters
Installation	Belt path or with base using True lock™ base installation
Weight of Car Seat	7.6 lbs (without base)