EN
26 PIPA instructions
1 - Tighten harness by pulling on the adjuster
strap. Pull any excess harness webbing through
the buckle towards the child’s shoulder and
pull on the adjuster strap. This may need to be
repeated several times for proper fit.
Verify that the harness is snug around the
child’s waist and shoulders.
2 - Position the chest clip so it is at child’s armpit
level.
Check that Child is Secure
Buckle is fastened.
Harness straps are not twisted.
Harness is snug – A snug harness cannot be
pinched, and should not allow any slack.
Chest clip is at level with armpits.
If harness slots are not AT or just BELOW
shoulder height, child could be ejected in a
crash or sudden stop. If harness slots need
to be moved, see section changing harness slot
position. (Page 18)
Make sure that nothing interferes with the
harness. Make sure harness is snug around
child and lays flat. Serious injury or death could
occur to a child that is not secured properly.
If child is not secured properly, child could
be ejected in a sudden stop or crash, resulting
in serious injury or death.
To Next Page
Loading...
Need help?
General
