Lower Anchors
The lower anchor belt can be used instead of a vehicle belt to install this child restraint.
The lower anchor belt MUST NOT be used rear facing or forward facing if your child
weighs more than 30 lb (13.6 kg).
The lower anchor belt and connectors are stored on the back of seat base in lower anchor
storage compartment.
1 - Open the lower anchor storage compartment door.
2 - Take out the lower anchor belt and connectors.
3 - Lengthen lower anchor belt for use by pressing adjuster button (1) while pulling
on belt (2).
4 - For belt routing, see p.50. To connect lower anchor belt to lower anchors in vehicle,
press connector firmly onto lower anchor and pull to check.
5 - Remove all slack from lower anchor belt by pulling loop at end of belt.
6 - To release lower anchor belt, press red button on end of connector while pulling on belt.
Store lower anchors when not in use. Place one lower anchor connector in each half
of the storage compartment. Fold excess belt webbing into compartment.
DO NOT cut the lower anchor attachment strap. It permanently secures the lower
anchors to the child restraint.
34 REVV
™
instructions
35REVV
™
instructions
2
4
3
1
1
2
5
6
To Next Page
Loading...
Need help?
General
