Rear Facing Installation
recommended until at least
2 years old (5–40 lb)
5
(2.3 kg)
30
(13.6 kg)
40
(18 kg)
Rear Facing
with vehicle belt & tether
with lower anchor belt & tether
Rear Facing Setup
1
- Rotate the seat rear facing. Push or pull on seat to make sure the seat is LOCKED.
2 - Select rear facing recline position 1–5 (BLUE) (p.32).
3 - If you are using a lap belt only, you must use recline position 5.
forward facing
5 4 3 2 1
1 2 3 4 5
rear facing
ALWAYS use the shoulder, hip, and crotch pads. Use infant insert with infants 5–11 lb
(2.3–5 kg) to improve the recline angle for smaller infants.
2
Check Installation
Seat is in rear facing recline position.
Seat is securely installed. Hold seat at the
belt path and move seat in all directions.
Seat should move less than 1 inch.
Tether is properly used and
attached to vehicle tether anchor.
1
Consult pages 42–52 for complete
installation instructions.
54 REVV
™
instructions
55REVV
™
instructions
rear facing
5 4 3 2 1
1 2 3 4 5
forward facing
To Next Page
Loading...
