EN
EN
Using UAS
(preferred installation method)
1 - Remove UAS belt from storage compartment
and route through forward facing belt path.
Belt MUST be routed under True Tension
™
door.
2 - Lengthen UAS belt as necessary and attach to
UAS anchor points in vehicle.
UAS belt MUST NOT interfere with the vehicle
seat belt.
3 - Remove all slack from UAS belt by pulling
loop at end of belt straight back from latch
connector (1).
Close True Tension
™
door (2). Replace seat cover.
Check Installation
Harness is stored.
Seat does not interfere with the vehicle headrest.
Seat is securely installed.
WARNING: Booster MUST remain secured
by UAS even when unoccupied to avoid
becoming a projectile in the vehicle.
WARNING: Check that child restraint is
securely installed before each use.
50 51
2
3
1
2
1
ROYL
™
instructions ROYL
™
instructions
To Next Page
Loading...
