EN
EN
Without UAS
This installation should ONLY be used if installation
with UAS is not possible.
1 - WARNING: When the child restraint is
installed without UAS, the leg rest MUST be
minimally extended and angled down towards
the vehicle seat.
2 - Leg rest MUST NOT be extended or angled out
enough that a child can step on it and tip the child
restraint over, which could cause serious injury.
3 - Leg rest MUST NOT be pushing into the vehicle
seat enough to lift the child restraint off the seat.
4 - When not using UAS, the back of the booster
seat MUST fit tightly against the back and
bottom of the vehicle seat. Adjust or remove
the vehicle headrest as needed to remove
interference.
Check Installation
Harness is stored.
Seat does not interfere with the vehicle headrest.
Leg rest is minimally extended and down against
vehicle seat.
Back and bottom of booster fit tightly against
vehicle seat.
WARNING: When NOT secured by UAS,
booster MUST be secured with vehicle belt
when unoccupied to avoid becoming a
projectile. Route vehicle belt as in forward facing
use or as though securing a child.
WARNING: Check that child restraint is
securely installed before each use.
4
52
1
2
53
3
ROYL
™
instructions ROYL
™
instructions
To Next Page
Loading...
