Nuova Simonelli MicoBar - Adjustments by Qualified Technician; Grinding & Milk Adjustments

+
-
Fig. 24
- C°
+C°
Fig. 25
OPEN
CLOSED
Fig. 23
5. ADJUSTMENTS TO BE MADE BY A QUALIFIED TECHNICIAN ONLY
Switch on the grinder to carry out the grinding
adjustment procedures.
NOTE: The procedure is possible also with the
appliance on.
•Putthekeyintoitslock.
•Turn the control panel hatchdoor key counter-
clockwise.
•Openthehatchdoor,togainaccesstothecoffee
grinder adjusting screw. Following the direction
of the arrows and using a 3 mm (0,12 in) allen
wrench, grinding of the coffee beans can be
adjusted to COARSER (counter-clockwise) or
FINER (clockwise).
•Lockthehatchdoor.
WARNING
5.1 GRINDING
ADJUSTMENT
NOTE: The procedure is possible also with the
appliance on.
•Putthekeyintoitslock.
•Turn the control panel hatchdoor key counter-
clockwise.
•Openthehatchdoor,togainaccesstotheadjust-
ing screw.
5.2 MILK FOAMER
ADJUSTMENT
5.3 MILK FLOW
ADJUSTMENT
(Temperature
Regulation)
NOTE: The procedure is possible also with the
appliance on.
To adjust both the flow and the temperature of the
milk delivery, turn the adjusting tap as follows:
•
Turn the milk suction tap CLOCKWISE/COUNTER-
CLOCKWISE to INCREASE/DECREASE the milk
suction and then DECREASE/INCREASE the
temperature.
• Turn the tap until the milk reaches the desired
temperature.
48
WARNING
The adjustments listed here below may be per-
formed by Specialist Technical Engineers ONLY.
Nuova Simonelli cannot accept any liability for
damage to people or property arising from fail-
ure to follow the safety regulations listed in this
manual.
To change the amount of air to the milk foamer and
therefore, to change the amount of foam, use the
adjustment screw as illustrated in the figure so as to
increase / reduce the air to the milk foamer.
EN