Nuova Simonelli MicoBar - Page 64

62
EN
•Attheendoftherinsecycle,themachinedisplay
will read as follows:
Leave the machine to heat up for a few minutes; at
the end of this time, the machine will return to its
ready status.
WARNING
We advise using the steam dispensing function
for a few minutes at the end of each de-scaling
cycle.
WARNING
You may notice drops of water and steam com-
ing from the hot water nozzle during the heating
stage.
•PresstheENTERkeyandthemachinewillbegin
a rinse cycle, taking on board 2 litres (0,53 gal)
of water from the container and then expelling it
through the steam nozzle.
•Duringthisstage,themachinedisplaywillreadas
follows:
•Whenthemachinehasfinishedthe2litres(0,53
gal) taken from the container, the display will again
read:
Press the ENTER key again for the machine to start
the second stage of the rinse cycle, taking a further
2 litres(0,53 gal) on board from the container. The
machine display will then read:
•PresstheENTER key;
•The machine will begin to suck up the solution
from the tank and at the same time, to expel hot
water from the nozzle.
•Themachinedisplaywillreadasfollows:
Once it has sucked up the first litre of solution, the
machine will stop for five minutes and then it will start
to suck up another litre of solution.
•Attheendofthiscycle,thedisplaywillreadas
follows:
•Rinse out the tank and refill it with clean water
(without switch off the machine).
NOTE: Use at least 4 litres (1.06 gal) of solution,
otherwise it will be necessary to restart the
cycle.
•Waitatleast5minutes.
•Attheendofthistime,thedisplaywillread: