66
ENGLISH
The set number of cycles pro-
grammed before washing,
has been exceeded.
The message will appear on
the display but the machine
will continue to deliver drinks.
Do a washing cycle (see para-
graph WASHING THE DELIV-
ERY UNIT AND MILK
FOAMER)
WASHING CYCLE
IS NEEDEDGIO
The set number of hours pro-
grammed from time of last
milk based drink before
washing, has been exceed-
ed.
The message will appear on
the display but the machine
will continue to deliver drinks.
Perform a washing cycle for
the milk foamer only. As in the
case of a complete washing
cycle, you must keep the key
pressed down for 5 sec-
onds without, however, insert-
ing cleanser tablets for this
group’s washing.
(See only points 1,2,3,4 of the
paragraph ‘WASHING THE
DELIVERY UNIT AND MILK
FOAMER’)
WASHING THE MILK
CIRCUIT IS NEEDED
DISPLAY CAUSE EFFECT SOLUTION NOTE
An end of service wash was
set for the delivery unit during
the programming stage.
An end of service wash must
be performed before the
machine is switched off.
Press the ENTER key as
shown on the display. The
machine will automatically
perform an end of service
wash, dispensing approx.
50cm
3
(3.0512 cu in) of water
and will then switch off.
SHUT DOWN CLEAN
To Next Page
Loading...
