8
CLEANING AND MAINTENANCE
INITIAL CLEANING. To remove miscellaneous residue, disassemble and wash juicer prior to initial use.
The machine must be disconnected from the power source and disassembled following the disassembly
instructions on page 5. Wash the juice pan, screen basket, cutter plate, blade nut, wrench, and food pusher in
Clean Cut per instructions and rinse thoroughly.
DAILY SANITIZING PROCEDURE
THIS PROCEDURE SHOULD BE CARRIED OUT AT THE START OF EACH DAY. BE SURE TO
WEAR VINYL GLOVES, AS USED FOR FOOD HANDLING, DURING THIS OPERATION.
1. ALWAYS TURN OFF AND UNPLUG YOUR JUICER BEFORE SANITIZING.
2. Pre-mix 1 level teaspoon of sanitizing powder in a glass of hot water, and mix with cold water to make 1
gallon of 100 ppm sanitizing solution. If your are using a liquid sanitizing solution follow the directions
on the bottle.
3. Assemble the machine, leaving the top off. Make sure the blade nut is tightened.
4. Wrap a dishtowel around the base to cover the Power Switch and Power Cord. Set waste container under
the juice pan spout. Spray approximately 1 pint of the sanitizing solution around the perimeter of the
basket screen, inside the basket screen, and onto the cutter plate and blade nut. Once done, remove the
dishtowel and thoroughly dry the base.
5. Thoroughly clean latch assembly, with particular attention to the adjustment thread.
6. Replace the Top. Lock latches. You should hear an audible SNAP sound when properly adjusted.
7. Insert the Pulp Tube into the pulp spout of the lid.
8. With receptacles under the juice spout and pulp tube, spray 1 quart of sanitizing solution down the feed
chute while the juicer is running. Follow by rinsing the sanitizing solution from the juicer by spraying
one quart of clean water into the feed chute while the motor is running. Allow the juice pan to drain.
Dispose of the waste solution.
9. Clean the Pusher with sanitizing solution and rinse thoroughly.
10. Test Before Use. Before use, check to make sure all the parts are in proper alignment. Plug your juicer
into an electrical outlet and test before use. The juicer is now ready for operation.
NIGHTLY CLEANING WITH A DISHWASHER. All juicing parts (cutter plate, blade nut, juice pan,
basket, pusher, and wrench) may be cleaned in the dishwasher. Scrub the basket with steel wool to remove
any loose pulp before putting the parts through the dishwasher. Use a detergent suitable for automatic
dishwashers. Make sure the screen holes in the basket are clear before assembly, if not, scrub again with
soap steel wool pad, rinse and assemble as instructed on page 6.
To Next Page
Loading...
Need help?
General