9
ATTENTION: IMMERSING, SPRAYING, OR HOSING THE POWER UNIT WILL VOID YOUR
WARRANTY. Do not immerse or spray the base and castle sections of the unit with water or other liquids.
The base, motor housing, and castle sections should only be cleaned with a damp cloth or sponge. It is
important that the rims of the castle and top be wiped thoroughly before assembly. Never spray or wash the
exposed shaft of the machine. The motor and electrical parts of the machine are not waterproof. Contact
with water or other liquids will damage the motor, bearings, and electrical system.
NIGHTLY CLEANING WITH “CLEAN CUT” CLEANING PRODUCT (recommended)
* Mix 1/3 cup Clean Cut powder in a plastic bucket large enough to hold the juice pan with enough hot
water to dissolve it.
* Put the cutter plate, blade nut, and pusher in the bottom of the bucket.
* Scrub the basket with steel wool to remove any loose pulp. Place it (upside-down) over the cutter plate.
* Place the juice pan (upside-down) over the basket.
* Add enough hot water to cover the parts by two inches. Let the parts soak overnight.
* In the morning, remove the parts from the solution, scrub the basket with steel wool to remove any
remaining pulp or stains. Rinse basket thoroughly.
* Clean the juice pan thoroughly to remove all stains. Use a bottlebrush to clean the juice pan spout. Rinse
thoroughly.
* Use a scrub brush to clean the cutter plate. Rinse thoroughly.
* Thoroughly clean latch assembly, with particular attention to the adjustment thread.
* Assemble machine as instructed on page 6.
(Clean Cut is a product available through Nutrifaster, Inc. only. Please feel free to call with any
questions regarding this product.)