- Save changes in memory by pressing “ENTER” key
- or Pass to the next window without saving the changes by pressing “NEXT” key.
- or Pass to the previous window without saving the changes by pressing “BACK” key.
The next window is the window that you choice the condition of time counting.
TIME STARTS TO
COUNT BY ?
START
EXIT PID
Select by using “TAB” key and selected parameter can be changed by using “INCREASE –
DECREASE” keys between “START” or “AFTER SET”. After setting the parameters;
- Save the changes in memory by pressing “ENTER” key
- or Pass to the next window without saving the changes by pressing “NEXT” key.
- or Pass to the previous window without saving the changes by pressing “BACK” key.
The next window asks you if you would like to save the whole process to the memory or not.
SAVE RUNNING
PROGRAM IN
MEMORY?
YES
EXIT PID
Select by using “TAB” key and selected parameter can be changed by using “INCREASE –
DECREASE” keys between “YES” or “NO”. After setting the parameters;
- Save the changes in memory by pressing “ENTER” key
- or Pass to the next window without saving the changes by pressing “NEXT” key.
- or Pass to the previous window without saving the changes by pressing “BACK” key.
The next window asks you if you will use humidity during the process or not.
IS HUMIDITY USED
WHEN PROGRAM IS
RUNNING ?
YES
EXIT PID
12
To Next Page
Loading...
