nvent JBS-100-A - Page 6

nVent.com | 6Raychem-IM-H56046-JBS100A100A6- ML-1805
1 in (25 mm)
Glass cloth tape
Pipe strap
JBS-SPA
adapter for
small pipes
Note: For 1 in (25 mm)
and smaller pipes use
adapter (purchased
separately) and install
between stand and pipe.
Position
adapter
this side
up.
Trim
12
13
15
Notch
14
• Fasten stand to pipe with label facing
desired direction of box opening. Do
not pinch heating cable.
• Loop and tape extra heating cable
topipe.
• Screw box onto stand until it stops. Do not overtighten.
• Insert cable tie through slots on stand and box, and tighten firmly to
prevent box rotation.
• Loosen locknut using adjustable pliers.
• Lift box and rotate. Make sure tab on threaded piece fits into one of
the four notches in box.
• Tighten locknut.
(Optional) To change direction of box opening: