nvent JBS-100-A - Page 7

nVent.com | 7Raychem-IM-H56046-JBS100A100A6- ML-1805
1
2
Screwdriver slot
Wire hole
Wire
16
This kit uses spring clamp style terminals.
Terminals use a steel spring to clamp the wire to provide improved
vibration resistance, reduced maintenance and faster installation.
To connect wires, firmly insert a slotted screwdriver into the square hole
(
1
2
) to open the spring. When fully inserted, the screwdriver will lock
into place, allowing you to remove your hand and insert the wire into the
round hole (
1
2
). Remove the screwdriver to clamp the wire. The wire is
held securely against the bus bar for low contact resistance over time
without the need to periodically retighten screws.
• Push screwdriver FIRMLY into
square hole.
• Insert wire into round hole.
• Use green terminal for braid and
ground wire.
• Remove screwdriver.
• Repeat for all connections.