Unless otherwise specified, Mellanox products are designed to work in an environmentally
controlled data center with low levels of gaseous and dust (particulate) contamination.
operation environment should meet severity level G1 as per ISA 71.04 for gaseous
contamination and ISO 14644-1 class 8 for cleanliness level.
Local and National Electrical Codes
This equipment should be installed in compliance with local and national electrical
codes.
Hazardous Radiation Exposure
•
Caution – Use of controls or adjustment or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.For products with optical ports.
•
CLASS 1 LASER PRODUCT and reference to the most recent laser
standards:
IEC 60 825-1:1993 + A1:1997 + A2:2001 and EN 60825-1:1994+A1:1996+
A2:20
Installation Procedure Overview
The installation procedure of ConnectX-5 adapter cards involves the following steps:
Step Procedure
1
Check the system’s hardware and software requirements.
2
Pay attention to the airflow consideration within the host system.
4
(Optional) Replace the full-height mounting bracket with the supplied short bracket.
5
Install the adapter card in the system.
6
Connect cables or modules to the card.
7
Identify ConnectX-5 adapter card in the system.
System Requirements
Hardware Requirements
A system with a PCI Express slot of corresponding bus width is required for installing the card.
For proper operation and performance, please make sure to use a PCIe slot with a
corresponding
bus width and that can supply sufficient power to your card. Refer to
the
Specifications section of the manual for more power requirements.
To Next Page
Loading...
