The adapter is being installed in a system that operates with voltages that can be lethal.
Before
opening the case of the system, observe the following precautions to avoid injury
and
prevent damage to system
components.
•
Remove any metallic objects from your hands and wrists.
•
Make sure to use only insulated tools.
•
Verify that the system is powered off and is unplugged.
•
It is strongly recommended to use an ESD strap or other antistatic devices.
Unpacking the Product
1.
Unpack the adapter package and place them on an antistatic surface, and verify you have
received the following items:
a.
ConnectX-5 Adapter Card, with a tall bracket assembled on the card.
b.
Short bracket (accessory)
2.
Check the parts for visible damage that may have occurred during shipping.
3.
Shut down your system if active:
Turn off the power to the system, and disconnect the power cord. Refer to the system
documentation for instructions. Before you install the ConnectX-5 card, make sure that the
system is disconnected from power.
Please note that if the card is removed hastily from the antistatic bag, the plastic
ziplock may harm the EMI fingers on the networking connector. Carefully remove the
card from the antistatic bag to avoid damaging the EMI fingers.
To Next Page
Loading...
