User Interface
BLDC Control Demo User's Guide, Rev. 6, 06/2020
20 NXP Semiconductors
• Speed slider—sets the required speed.
• DC-bus voltage gauge—shows the actual DC-bus voltage.
• DC-bus current gauge—shows the actual DC-bus current.
• DC-bus current limitation slider—sets up the DC-bus current limit.
• Demo mode button—turns the demonstration mode on/off.
• STOP button—stops the whole application.
• Application State Notification—shows the actual application state and faults.
Figure 18. FreeMASTER control page
The MCAT tuning tool plug-in module is in the FreeMASTER GUI. This tool is targeted at
motor-control applications, where you can change the motor-control parameters or adjust the start-up
and control parameters. Each tab represents one submodule of the embedded-side control, and tunes its
parameters. For more information, see Sensorless BLDC Control on Kinetis KV (document AN4642).
Here are the basic instructions:
• To start the motor, set up the required speed using the speed slider.
To Next Page
Loading...
